Carprog full errors “Damaged parts -6 or 4”(solved!)

These are customer solutions to Carprog full V7.28 errors “Damaged parts -6 or 4” with detailed information like “Damaged parts – ARM7 +4 ARM7(master mcu) can’t be replaced contact seller to repair your device.”

Error:
Damaged parts -6
Damaged parts -4
Error message：
Damaged parts – ARM7 +4 ARM7(master mcu) can’t be replaced contact seller to repair your device.

Damaged parts -6
Demaged part -6 means you have broken mcz33290(ISO K Line Serial Link Interface)

If you look at 2 pictures when you click HW test you can see some ic-s with numbers on it, under 6 is mcz33290. You can take it from D1 adapter just for probe – there is mc33660 – its the same;

When the Carprog full  interface came with a problem “Demaged part -6”, tested with A9 and all was ok then.

Damaged parts -4
had a problem with my Carprog clone when connect it to computer and push “Hardware test”. the result is error in some “PIN” a final error is “Damaged 4 parts”.

Now make the A9 Adapter and everything will be OK in the end

Maybe, some guys may be unlucky if even do so. And that is another possible reason:
the Voltage is too large and heat is not good —> overheating then burn the 4th mcu chip. Replace the 4th chip using a heat gun or sent it back to seller to repair your carprog full.
NOTE: solutions above is from caprog users. You may be at risks to try it. UOBD2 just offers information here but won’t be responsible for it. Good luck!
Carprog full set cables