Now I have succeeded in one Carprog unit(CARPROG FULL V9.31), with help of a sewing needle. It will go wrong because I get up
two pin, and then I can not solder back the faulty pin.
Now I have managed to get another one ready for easy flash with J-Link adapter.
But I will make another one to experiment with, and rebuild to
full function or better.
Below is some useful tips from forum bros. Wish this helps
*** autocargo says:
… find scrap electronics board and practice on that. I use thin syringe
needle and magnifying glass.. No point practicing on your working CarProg….
Use thin solder tip or hot air off course…forgot to say… but
I don’t think you would be doing it without applying heat…
*** demelec says:
needle under leg needed lifting and heat with hot air, then
very carefully lift only a little just so it
separates
from pcb solder
Soldering iron you have to use very thin tip and just touch very end of leg
to remove ( solder at very end so not actually touching leg) then you can lift
with needle
And always use solder flux
Flux is the main key to easy
working
CARPROG was designed with regard to demands of our customers to have universal tool for car radios, dashboards, immobilizers repair including advanced functions like EEPROM and microcontroller programmer.
Tuesday, November 22, 2016
Thursday, November 17, 2016
Carprog 8.21 clone doing Skoda Yeti 2012 with nec&24c64
Have done odometer correction on Skoda Yeti 2012 with nec & 24c64 by
Carprog v8.21 online version clone.
Connect Carprog with adapter and connect to vehicle
Open Carprog 8.21 software
Select DASHBOARD
Select Skoda
Select Skoda 2009-> DIAG v0.2
Select Change KM
Connecting CAN…
Reading mileage please wait
Carprog read KM 58117
Change KM to miles
Enter value you need, click on Change
Follow system prompt.
Done!
Connect Carprog with adapter and connect to vehicle
Open Carprog 8.21 software
Select DASHBOARD
Select Skoda
Select Skoda 2009-> DIAG v0.2
Select Change KM
Connecting CAN…
Reading mileage please wait
Carprog read KM 58117
Change KM to miles
Enter value you need, click on Change
Follow system prompt.
Done!
Subscribe to:
Posts (Atom)